Control Interface and Factory Defaults
Console logic interface
ASP510 can accept logic control signals from a host mixing console so console Solo, Dim, Talkback and Bypass functions can continue to control the monitoring system.
The logic inputs use floating AC/DC opto-isolators and can detect positive or negative control voltages between 2 V and 24 V.
Console logic systems differ between manufacturers. Refer to the console or DAW control-system documentation before connecting external logic signals to ASP510.
Remote Control connection
The Surround Processor and Remote Control are linked by the REMOTE sockets.
- Link type: RS485
- Cable: non-reversed CAT5 FTP, shielded twisted pair
- Supplied cable length: 5 m
- Maximum recommended cable length: 20 m
Factory default state
When ASP510 is first powered, the default setup is:
| Setting | Default |
|---|---|
| Monitor Format | 5.1 |
| Alternate Speakers | Off |
| Stereo Record Source | Bus |
| Monitor Source | Surround Record |
| Encoder/Decoder | Out |
| Guide | Off |
| Ref | Off |
| Reference Level | -10 dB |
| Volume | Fully counter-clockwise |
| Dim | On |
| Dim Level | -20 dB |
| Cut | Cut |
| Mode | Cut |
| Speakers | On |
| Monitor Trims | 0 dB |
To restore these defaults, hold Bypass until the button flashes, then release it.
Next steps
Continue to Room Setup and Calibration.